CureZone   Log On   Join
Re: Please help...why red bumps after zapping??!?! Does this help???
marianne Views: 3,698
Published: 19 years ago
This is a reply to # 78,939

Re: Please help...why red bumps after zapping??!?! Does this help???

I found this info in my computer file and don't know how old it is.


You must electrify one to two hours daily for three weeks.

1.Build or purchase a ready-to-use device, or put finishing touches on a nearly-completed kit
costing $89 from Action Electronics, 1300 E. Edinger, Santa Ana, CA 92705. (714)-547-5169.
2.Prepare and label a sea-salt-in-water solution for electrode wetting. Use 1/2 teaspoon of Sea Salt
in a 2 ounce dropper bottle. Greater salt concentration can cause cosmetic skin burns, irritation
and rash. Add water and 4 drops of Purex or Clorox, a few drops of wetting agent like Kodak Photo
Flow, ethylene glycol, or 409 kitchen spray-cleaner. Let salt dissolve. Filter through paper towel
to clarify this storable conductive interface between cotton covered electrodes and skin. NEVER
let bare metal electrode or any small area of metal touch skin directly, or it will burn. Use natural
salt only, not table salt containing Iodine for goiter and aluminum and silicates to insure easy

Printer-friendly version of this page Email this message to a friend
Alert Moderators
Report Spam or bad message  Alert Moderators on This GOOD Message

This Forum message belongs to a larger discussion thread. See the complete thread below. You can reply to this message!


Donate to CureZone

CureZone Newsletter is distributed in partnership with

Contact Us - Advertise - Stats

Copyright 1999 - 2022

2.375 sec, (1)