MBGT UPDATE: thursday morning

Last night I tried modifying the GT by spiraling the conduction cable and adding salt water.

I captured a small entity on the right side of my head, a little further away from my skull about 1 foot out. It had my mothers voice and so was perhaps a personality entity. It is fascinating feeling it sink down into the water and be sucked into the cable; the water literally becomes ectoplasmic and "moves" like a small implosion is going off inside. Truly fascinating. There is not doubt the water assists in the discharge. i will have to try a whole body bath with the grounding wires plugged in... THAT will be something!

When I got tired of the position I flipped over and placed my left hand into the trap. That is when a very bizarre capture occured: I felt like I got the wind knocked out of me... but also took a deep refreshing breath at the same time. Both sensations happened without physical breath. Something left my lungs and diaphragm and sank right down into the water! In retrospect, there is not longer a twitching underneathe my sternum where no doubt this entity was attached before.

In spite of these exciting updates- I found I am also still vulnerable to psychic attack. for the record- my room mate is a meth smoker and so a huge doorway is open to these forces. Anyway- something dropped right into me - it wsan't an entity but rather some kind of attack from an entity. It pissed me off but does not feel to be permanent.

Interestingly enough, despite the 2 captures I found the sucking power to be less than before... but most likely it is due to a change in my water charging protocol.

On the first night I charged the glass that I drank for 1 hour: the intent was "freezeRemoveGroundEntities", and the bucket water was "SuckTrapGroundEntities" which I charged for 5 hours! Well last night perhaps due to laziness I only charged my drinking water for 5 minutes with "strongboundariesGrounded" and the bucket water for 5 minutes with "groundEnergyStrongly". Evidently, the water responds to specific intentions and longer charging times.

Tonight I am going to be making a modification by adding an additional wire of a thicker gauge to increase the conductivity and reduce the resistance. I will also add in some sulfur powder (DMSA) tomorrow night.

My goal is the snag the Big One that has been causing me trouble these past 3 years. Wish me luck...