20Kw Free Energy Motor Going to Mass Production

Free Energy Motor Going to Mass Production
Motor Can Produce 20 Kilowatts - Enough for Most Homes

There have been so many successful experiments in the field of "free energy" systems that I personally consider the principle to be proven. But what has been lacking is for a system to reach the point of mass production of devices which anyone can buy and use. Perhaps a new magnetic motor called "The Perendev Magnetic Motor" invented by Michael Brady will be such a system, for it is reported that it is entering into the first production run. Apparently the motor uses a proprietary arrangements of permanent magnets to turn a rotor, which can then power a conventional generator. The life of the magnets is said to be about 15 years.
Details can be found at the Perentech website:

http://www.perentech.com/devices/perendev/magnetic_motor/

There is even a waiting list form you can fill out to buy the Perendev Motor when they start rolling off the production line. The motor will initially be a bit expensive, 8500 Euros, but that is usually the case with a new technology, and it is stated that prices will come down once production is in full swing.

A news conference is scheduled for September and the motor will be demonstrated on German TV at that time. The motor (powering a generator) is said to produce 20 kilowatts (continuous output), which is enough for the peak requirements of most houses. At non-peak hours excess electricity can be sold back to the power grid which would, in part, offset the initial costs of buying the system.

Here is an excerpt of a news release article at:
http://pesn.com/2004/06/30/6900029PerendevPowerMagneticMotor/


Perendev is Tooling Up for Magnetic Motor Mass Production in Europe
All-magnet motor poised to be first to reach market. German manufacturer licensed to manufacture 20 kw unit for Europe and Russia. Estimated cost for first units: $8500 Euros.

by Sterling D. Allan

Copyright © 2004, all rights reserved

Pure Energy Systems News

JOHANNESBURG, SOUTH AFRICA

For centuries, inventors have been claiming to come up with magnetic motor designs that use nothing more than the power of permanent magnets for the motive force; and for the same amount of time, mainstream Science has responded that this is impossible. "It has been proven mathematically that no combination of permanent magnets in any arrangement will generate power." [1]

History tells us that what has been proven in many people's back yards and garages does not always coincide with mathematics of the day.

Refusing to be daunted by what he considers to be petty dogmas of academic science, inventor Michael J. Brady of Johannesburg not only claims to have produced such a device, but reports that his company, Perendev Power Developments Pty (Ltd) is now in process of manufacturing it on a large scale for markets in Europe, Russia, and Australia.

Perendev's new website was published recently at Perendev-Power.com with the assertion that they have achieved the milestone of producing "the world's first fuelless magnetic engine."

Other inventors who claim to have built working all-magnetic motors would take exception to the Perendev claim to being the first, as stated on the site. Brady mentioned that he had noticed some inaccuracies on the wording on the site and that he would be addressing them.

What is yet to be attained by anyone is a market-ready device. If Perendev continues on the track claimed on its site, it could achieve that distinction, and set the hitherto balking scientists community into motion to come up with theories of why it works.

Brady estimates that the first units will sell for around $8500 Euros, but that the price will decrease as volume sales increase...

A page about the motor says that the motor works "by focusing the magnetic field, the angles of the magnets and a special method of shielding." Also, "the motor does not require external power to start up." Brady reports that tests run have shown no diminution of magnet strength over period of motor operation, which was two months in one instance.

As the stators become engaged, the three rotors with off-set magnet alignment begin to spin. The speed is controlled by a governor. Without the speed control, the device would accelerate to destruction.

Brady also states that a 4 megawatt unit is plausible with this design, and has been rendered in conceptual blue print form.



Four Megawatts! Wow! That's like a small power plant. Such a device could revolutionize our world, in particular the third world countries which cannot afford the type of power plant which continually requires consumption of expensive fuels to create electricity. A German company, the name of which is not yet released, is now tooling up to begin mass production and has aquired the licensings rights for all of Europe and Russia. Other firms are in negotiations for licensing rights in the U. K. and Australia.

"The name of the German company will be revealed when they have finished tooling up and are ready to begin production, which Brady estimates will take place in a month or two. He said that these units will be consumer ready for application in home use, pending the stamp of approval from TUFF. Brady also plans to allow German television crews to document the device for public view.
"Twenty kilowatts is adequate to handle the peak load of most homes. Ran continuously at that rate, the excess produced during average use, which is five percent of peak use, could be sold to the grid for a quick return on investment. It will put out quite a bit more than twenty kilowatts, said Brady. 'That is what it is rated to produce continuously.'

"In May he reported to have tested the unit with a larger alternator rated at 60 kw 'with very little degrading of the motor's performance.'"


One can imagine a future scenario in which there are millions of these devices, all of them selling that 5% of power back to the power grid: an interesting scenario.

There are quite a number of magnetic energy devices in various stages of development, but the Perendev Motor appears to be the closest to starting mass production. Here is a list of magnetic devices currently in development.

http://freeenergy.greaterthings.com/Directory/MagneticMotors/

Press conference and TV demonstration coming this month, September 2004! Could it be that even as we wage wars to grab oil we stand at the brink of a revolution which will make oil unnecessary? I hope the plans for the Perendev Motor work out well because only a breakthrough in the free energy area is going to save this planet and save human civilization. In a letter on his website scientist Tom Bearden , co-inventor of the Motionless Magnetic Generator (MEG) explains why other "conventional" forms of alternate power production will not do the trick.


"The only thing I personally can do, is try to get out as much information as possible on energy from the vacuum, because systems taking their energy freely from the active vacuum are the only viable solution that could be done in time, given a significant U.S. scientific and government effort.
"As to the MEG: We are a very hard year away from being able to put devices into mass production. There are some very special areas (control of the Aharonov-Bohm effect with precision, control of nonlinear oscillations including chaotic oscillations that are typical of highly nonlinear far from equilibrium systems, etc.). That's some expensive research, with very sophisticated instruments, special techniques, and by specialists in about four different and unusual areas. When we get funding, that is exactly what we will launch into. Until then, there will be no MEGS that can be mass produced for the world market.

"There are also other systems by other inventors, that are in fact ready for pre-producing engineering right now. At least three that I'm personally aware of. But again, the U.S. scientific community is not doing anything creative and innovative in energy; simply go check out the NAS, NAE, NSF, DoE, national laboratory, and university websites. The only thing - energy from the vacuum, cheaply and plentifully - that could save us when the centralized grid gets destroyed, is also the only thing NOT being worked on by our scientific community."



That someone has managed to get this close to actual mass production is something astounding, given the active attempts by the oil companies and energy cartels to suppress such technologies. Of course, it is happening outside the United States, and Tom Bearden's MEG will be produced outside the U.S. since he has stated flatly that it is absolutely impossible to develop free energy in the U.S. at this time. One must go to a country where there is more freedom! Just consider that we have a president and vice president who are oilmen themselves! America has given so many new technologies to the world in the past, the automobile, the airplane, the light bulb, but in the case of free energy American Corporations prevent serious work or research in this area to protect the status quo of their profits.
There is no question that the first step in this new direction will be to vote the oil companies out of office. And we must pass new laws to prevent the kind of corporate takeover of government that we are witnessing now in the Bush administration. The energy policy of America has degenerated into this: steal oil.

Here are some related web pages:

Perendev-Power.com - Perendev's official website.
PerenTech - in process of finalizing licensing for North America
Pure Energy Systems News

Perentech Page
http://www.perentech.com/devices/perendev/magnetic_motor/

Perendev Wait List Sign Up
http://www.perentech.com/order/index.html

Tweet