Experimenting this Week

Found that article about adding a drop or two of hydrogen peroxide to CS to improve the quality and clean it up a bit or some such. So I tried it.

I put some golden full moon Colloidal Silver that I made a few months ago in a quart jar, added a couple of drops of hydrogen peroxide to it, and waited a few minutes. Much to my surprise it was completely clear (instead of golden) when I came back to check it!!!!

Well I had been wishing for a few years that there was some way to reduce the particle size, and got very excited about this.

I began to drink this Colloidal Silver in distilled water with a few drops of bloodroot. Not sure if it was placebo of hope or what but I felt very enthusiastic and noticed slight tiny little sensations in my body that I never felt before. The night I added a few drops of bloodroot I had a dream that the bloodroot told me "We are helping the little balls burn up disease!" ....

Well I was just about out when the last full moon arrived, so I made some more. And it came out golden, as mine always does when I make it during the full moon, except every once in a while, perhaps because I cook it too long, when it turns gray.

Much to my surprise, when I added a few drops of hydrogen peroxide to my fresh batch of golden Colloidal Silver , the water turned very cloudy and yellow!!! Not only that, but when I shot a laser beam through the murky water it was much, much darker and thicker!!!!

So I began diluting until it became clear, and the beam was to my liking. I like it pale red and narrow. The next morning I shot the beam through the diluted batch again, and it had become invisible over night. I am not sure what to make of all this.

Has anyone experimented with putting a few drops of hydrogen peroxide in Colloidal Silver and observed anything like this? Does anybody have any idea what is going on? A friend of mine thinks I should throw it out, but I am thinking the beam became stronger because the silver was broken down into smaller particles and I have a super good batch.

And I should just dilute it with distilled water until the beam is smaller and the water is clear. I do not want to throw away good CS.