CureZone   Log On   Join
Image Embedded Video Embedded Concise Instructions - Learn how to Build Your Own Beck Electrification Unit/Zapper for you DIYselfers
 

Lugol’s Iodine Free S&H
J.Crow’s® Lugol’s Iodine Solution. Restore lost reserves.



Energy Awareness Course
Use CureZone kode to get a free session!



Clarkia Extra Strong
Clarkia Tincture 2 oz, 4 oz, 8 oz, and 16 oz


unleashhealth Views: 11,214
Published: 14 y
 

Concise Instructions - Learn how to Build Your Own Beck Electrification Unit/Zapper for you DIYselfers


All information and diagrams provided by Unleash Health
All rights reserved, Copyright 2010 (Rev. 5/26/10)


This document has been compiled to help others and assist them with building their own blood electrification devices. This guide is relatively simplified but should give you a good understanding of how to put a functioning unit on a solderless breadboard for your own use and/or experimentation.


Please note: This method of development of the electrifier is meant for self construction and use, and is not how the device offered is built. It is a professionally built product with pcb mounted components and construction.The information has been organized into their respective categories and I hope has been made in a conveniently browsable format.Below we begin with the most attention requiring part of beginning your project:


A Schematic drawing by Dr. Bob Beck laying out the connections, components and information about his circuit.


Dr. Beck's Blood Electrifier Schematic Biological Electrification
(click to enlarge)

 

 

 

Components

Below is a list of the compiled necessary electronic components with their schematic codes.

Code Part Name Part Type
R1 2.4 Meg Ohm Resistor
R2 150 K Ohm Resistor
R3 100 K Ohm Resistor
R4 100 K Ohm Resistor
R7 820 Ohm Resistor
D1 18 V Zener Diode
D2 18 V Zener Diode
C1 0.1 uF Capacitor
C2 22 uF 35 V Electrolytic Capacitor
U1 LM358 Dual - Op Amplifier
S1 (optional) (On - Off) Toggle Switch
R5 100 K Ohm Linear Potentiometer
J1 3.5mm Input Jack
B1 - B3 9 V Battery Battery Snaps
CR1 3mm Orange LED

 

 

Basics

 

The basic tools that you may find useful in using for this project are as follows:

1. Solderless breadboard
2. Set of breadboard jumpers
3. Wire stripper/cutter
4. Solder and a soldering iron
5. 22 - 24 gauge wire


 

Setup Video


How to Construct a Blood Electrifier Circuit following Dr. Beck
This illustrated video guide was created to help others who are interested in creating their own blood electrification circuits on a solderless breadboard and the use of a basic set of breadboard jumper wires. This project requires some minimal soldering and can be accomplished relatively easily in a short amount of time

 


I've tried to make this instructional page to be relatively self explanatory, if there are any issues or questions please send me a message at connect@unleashhealth.com

To your health and a wonderful day!


Beck Protocol Information, Technology & Resources
www.unleashhealth.com

 

 
Printer-friendly version of this page Email this message to a friend

This Forum message belongs to a larger discussion thread. See the complete thread below. You can reply to this message!


 

Donate to CureZone


CureZone Newsletter is distributed in partnership with https://www.netatlantic.com


Contact Us - Advertise - Stats

Copyright 1999 - 2024  www.curezone.org

0.109 sec, (7)