Achieving greater percent of particl... 
Rebel
20 y
1,400
Hi Folks,
I was wondering if anyone had suggestions on how I can get the greatest ratio of silver particles rather than ions. I have a homemade generator made from a 30v DC adapter, .9999 fine silver 12 guage wire, and I heat the water to near boiling. Will adjusting the apporatus so that the electrodes are as close as possible (without touching) achieve a greater particle ratio? Is there anything else I might be able to do. Thanks in advance for your input.- Re: Achieving greater percent of par... Karlin
20 y
1,235
MoreThis is a reply to # 82,205Timing might have a lot to do with it.
Learning when to quit help reduce the particle - to -ion ratio.
Too long a time period with the process going makes too many large particles, I have found.
'Floaties" show up, silver coloured particles visibvle to the naked eye.
Too short a time with the current flowing means a low ionic transfer.
i don't have much else to offer on this though. Are you, of course, using distiled water?
Karlin
- Re: Achieving greater percent of par... ginseng007
19 y
1,413
This is a reply to # 82,205new machine on ebay called the silver bullet: its a take off from the frankenstein generator: he sent his out to the laboratory and it was into the atomic range for particle size. to have your particle size tested will cost $350.00 he has done it. now the silver bullet has duplicated it. its new on ebay for 23.95 using his method and improvising with his own. perfect high quality CS at 12PPM.
- Re: Achieving greater percent of par... Karlin
20 y
1,235
Share:
Translate This Page: