Thanks JohnG,

I've been Rifing for years now. I just normally don't post to this forum - I'm normally found on the Rife Forum. I can't dowse or muscle test so I have to go with how I feel the next day after treatment.

Some of the Newport scripts have as little as 60 second dwell times so I really don't see how this would be of benefit using as SG-1 since I, and many others, have found that you need to multiply 'contact' or 'plasma' dwell times found in scripts by a value of 8x or so if using an SG-1.

For example, for an Enterococcus Faecalis infection I have to run an average of 15 min. using a Bare plasma system to eliminate the infection. But when using the same frequency using an F165 / SG-1 combination, I'll need to run between 2 - 3 hours to get the same effect.

This is why it's important to know if Newport intended his dwell times to be used with only an F165 (contact mode) or in combination with an SG-1, in which case many of the dwell times will definitely have to be increased to notice an effect.

In the past I haven't used many of the Newport scripts (have used DNA & frequencies from other lists). But Newport has some of the Lyme complex pathogens covered within his sets for which there are no DNA frequency sets.

So I'm about to create a few F165 master scripts which will combine many of Newport's programs within one scr1pt (eg: One master scr1pt for all Newport Biofilm sets, one master scr1pt for all Newport Lyme & co-infection sets, and one master scr1pt for parasites which have shown up for me in the past via dowsing, EAV testing, etc.)

I'm sure dwell times vary from person to person, depending on whether they're just beginning Rife therapy. But at this point, I just want to know if Newport intended his dwell times to be used with an F165 only -or- with an F165 / SG-1 combination. Because, in general, the dwell times will vary greatly between these 2 approaches.

Hi musimesipomahat,

You have hit on exactly why I posted the question. I'll be putting my F165 scripts into a loop to be run on the SG-1, just as I'm doing with all my existing scripts. But at the same time I wanted to get a confirmation of the intended dwell times of each frequency being run within the loop since the SG-1 will be used.

Hopefully Newport will see this thread soon and post his comments.

Thanks to all who have responded so far.

<<
Dwell seems to be relevant only to the volume/infection level/heaviness/load or whatever you want to call it.
<<

Yup, but everyone keep in mind that most of the frqs are designed to eliminate the pathogen by destroying a needed Nucleic Acid. In most that is also the Acid that causes immune suppression and hides it from your immune system.
So volume is the KEY here. To refresh your memory you need to go back to old posts on FSME and the pain we went through trying to remove that. This was before targeting the toxic acid instead of the organism itself, it cannot survive without it but killing it while leaving the toxic acid was driving some nearly to the nut house..

The other benefit of hitting the acid is that its VERY difficult for the Frankenstines to change that. However Archon can interfere with it..