Can PC software substitute a Rife ma... 
krosser
13 y
11,551
MoreHi everyone who uses Rife devices!
In a nutshell, I can't get a Rife machine and have found a software programe on the Internet that claims to be a substitute for a physical Rife machine. It uses an audio output of a sound card on your PC/laptop. There are electrodes attached to the output with a cable. I wonder if that would work as it is my only option to start using Rife?
Please let me know if you have had an experience with such software.
Maybe Newport would be so kind to comment as well...
Thanks in advance!- Re: Can PC software substitute a Rif... Tizona
13 y
11,446
This is a reply to # 1,887,677Can you provide a link to the machine?
I think it would be very helpful- Re: Can PC software substitute a Rif... krosser
13 y
11,215
This is a reply to # 1,887,693Well, I was looking for a Rife machine on ebay but found this software...
I will send you the link as I don't want to advertise it here.
Hope you understand.
P.S. All I am asking is a general question whether any software can be used to replace a physical Rife machine or not...
Thank you- Re: Can PC software substitute a Rif... parazapper
13 y
11,274
MoreThis is a reply to # 1,887,704Since neither a computer nor a speaker system is designed to provide a safe electrical source for connecting to the body, I would avoid trying either. No one wants to be the news story of being electrocuted by hooking themselves up to a stereo or computer. I also do not think that it is a great honor to win the Darwin Award.
You can easily and cheaply build a manually operated BBBE with 3 batteries, a couple of resistors, and a toggle switch.
There are instructions on the internet for this, as well as for ones with a op-amp output.
Be wise, be safe.
More
- Re: Can PC software substitute a Rif... Tizona
13 y
11,198
- Re: Can PC software substitute a Rif... parazapper
13 y
11,208
- Re: Can PC software substitute a Rif... parazapper
13 y
11,208
- Re: Can PC software substitute a Rif... krosser
13 y
11,187
This is a reply to # 1,887,927Would it be less risky if one uses a laptop/netbook on a battery without being connected to a socket?
I would be grateful if you provide more info or links to those instructions... If possible.
If not, I would just have to take my risks... I can't just sit and do nothing and be scared of everything, life is a gamble...- Re: Can PC software substitute a Rif... parazapper
13 y
11,266
This is a reply to # 1,887,983Yes, using a laptop, disconnected from the AC mains, would likely be safer. It depends on the battery voltage. 12 to 15 volts is probably ok.
PC generated frequencies can be fairly good, if done right. The impedance of the audio output is not ideal though.
- Re: Can PC software substitute a Rif... krosser
13 y
11,113
This is a reply to # 1,888,186What if I use an amplifier with a DAC feature to boost my sound card?
How many watts do I need to get a decent output on metal electrodes? Is 2x15W enough?- Re: Can PC software substitute a Rif... Tizona
13 y
11,484
This is a reply to # 1,888,376this is something you might be interested in. It's a combination zapper/rife unit, only cost $100. I would get this myself, but I'm very sensitive to electricity, and I can't really use zappers
http://www.ebay.com/itm/Digital-Zapper-AV9f-Hulda-Clark-Digital-Frequency-Gen...
- Re: Can PC software substitute a Rif... krosser
13 y
11,127
This is a reply to # 1,888,441I already have one of those... :)
And I am not really satisfied as it is not precise enough and I can't use any of Rife's frequencies with it... Not the best investment, to be honest...
Do you know anything about amplifiers though? Maybe you can help me decide which amplifier I should get to power up my netbook for Rife software?- Re: Can PC software substitute a Rif... Tizona
13 y
11,235
This is a reply to # 1,888,445why is it not precise enough? it only allows you to select certain frequencies?
And no, sorry, I don't know about amplifiers - Re: Can PC software substitute a Rif... parazapper
13 y
11,142
This is a reply to # 1,888,445Thanks. I had already noticed that 0.1 kHz means no 15 Hz, no 20 Hz, no 40 Hz, etc.
Having more than a few frequencies is not a major bonus unless they are accurate.
Please provide a deeper critique of this zapper so that others reading this forum will know.
- Re: Can PC software substitute a Rif... krosser
13 y
11,128
This is a reply to # 1,888,475Not only does it mean you can't select frequencies like 15 Hz, 20 Hz, 40 Hz, etc., but also you can't select frequencies like 0.95 kHz, 5.58 kHz, 495.22 kHz, 824.37 kHz, etc. You can only use the ones like 0.9 kHz, 22.5 kHz, 30.0 kHz, 137.5 kHz, 372.5 kHz, 380.0 kHz, 425.0 kHz, etc.
So for loads of very important frequencies it's useless.
Hey Parazapper, can you answer to my question regarding an amplifier please?
- Re: Can PC software substitute a Rif... krosser
13 y
11,128
- Re: Can PC software substitute a Rif... parazapper
13 y
11,302
This is a reply to # 1,888,445>- Do you know anything about amplifiers though? Maybe you can help me decide which amplifier I should get to power up my netbook for Rife software?
I am not sure how to respond to this. I have built a number of amplifiers over the years for various purposes. A lot depends on what kind of output you need, the signal source, frequencies, and impedances.
I would certainly go for a battery powered amplifier that can output a small signal up to 800 kHz through a 1k ohm resistor. It should also be able to go as low as about 10 Hz. These spec's will make it hard to find.
For square wave frequencies in the range of 10 Hz to 30 kHz, you might be able to modify an old zapper.
- Re: Can PC software substitute a Rif... krosser
13 y
11,011
This is a reply to # 1,888,759You and your batteries!! LOL
Well, I'm getting an amplifier with a range of 5Hz to 30kHz... a professional one...- Re: Can PC software substitute a Rif... parazapper
13 y
11,219
This is a reply to # 1,889,023Batteries, better safe than the possible alternatives.
I do not have any objection to connecting to the wall as long as it is IEC60601 rated.
>- getting an amplifier with a range of 5Hz to 30kHz
Sadly, that will not produce a good square wave. The best amplifier will have a range up to about 800,000 Hz in order to generate the harmonics in a square wave.
If all you need is an audio frequency sine wave then it will be fine.
- Re: Can PC software substitute a Rif... parazapper
13 y
11,219
- Re: Can PC software substitute a Rif... krosser
13 y
11,011
- Re: Can PC software substitute a Rif... Tizona
13 y
11,235
- Re: Can PC software substitute a Rif... krosser
13 y
11,127
- Re: Can PC software substitute a Rif... Tizona
13 y
11,484
- Re: Can PC software substitute a Rif... david1o1
13 y
11,116
This is a reply to # 1,888,186[quote]
It depends on the battery voltage. 12 to 15 volts is probably ok.
[/quote]
It depends on the battery voltage, and on the battery charge, and how wet are your hands, and how wet are your electrodes, and if you have cuts on your hands or not.
I have used up to 36VDC with wet electrodes without any side effects. But the high amount of current circulating in the body does not seem to be the key to kill parasites... I have taken up to 11ma of current and the parasites were still moving after the session... Damn it !- Re: Can PC software substitute a Rif... parazapper
13 y
11,115
This is a reply to # 1,888,751>- up to 11ma of current and the parasites were still moving after the session
Were you using paddles and pads in the augmentation mode? Makes a big difference.
- Re: Can PC software substitute a Rif... parazapper
13 y
11,115
- Re: Can PC software substitute a Rif... krosser
13 y
11,113
- Re: Can PC software substitute a Rif... parazapper
13 y
11,266
- Re: Can PC software substitute a Rif... Tizona
13 y
11,198
- Re: Rife Software Link & description krosser
13 y
11,457
This is a reply to # 1,887,704Well, I have found the actual web site where they sell the software... not some ebay seller...
Here is the direct link for everyone interested
http://www.rifesoft.com/content/buy-now-rife-generator-software
You can buy and download directly... or order a CD copy. Up to you...
BTW they offer a small free program with a few Rife frequencies
http://www.rifesoft.com/content/rife-generator-free-download
In the meantime, I had to do my own research regarding amplifiers and such, since no one here is helping... Well, I have come to conclusion that a decent amplifier is crucial for achieving best signals.
Also seems like there is no need in DAC amplifier (google DAC if you don't know what that means). I also had to learn it.
I am currently thinking of getting a 2x25W TA2021B amplifier. It is quite affordable and should perform fine.
Will try to use my copper electrodes from a frequency generator first, but will probably also get large TENS electrodes as it is easy to connect them to an amplifier. Perhaps, I'll even get two stainless steel sheets 300x200 with alligator plugs and wires... Will see...
- Expand 20 messages, 21 to 40 of 40 truecolor
13 y
11,389
- Re: Can PC software substitute a Rif... parazapper
13 y
11,274
- Re: Can PC software substitute a Rif... krosser
13 y
11,215
- Re: Can PC software substitute a Rif... Tizona
13 y
11,446
Share:
Translate This Page: