You can use quartz crystals to transmit frequencies through the air. The frequencies have a very wide range. You might run a frequency in your room and then hear the neighbors start sneezing profusely. It is almost frightening what you can do with this, as you can also control the weather this way, but that's a topic for another post...

This is for those who only have a frequency generator, with no plasma or subspace add-on. You do not have to spend $1000's on fancy devices. Quartz is a powerful frequency transmitter, due to its piezoelectric properties. No longer will the poor remain sick due to lack of funds. Now with a cheap quartz crystal and a $100 frequency generator from Ebay (for example), you have everything you need to experiment with Royal Rife's research.

You will need:
1) frequency generator (one that can send out pulsed DC or positive offset waves)
2) a quartz crystal. The size does not appear to matter, even a thumb-sized one is very powerful. You will need to block all light from reaching it as the light can distort the frequencies you run. Place an opaque black plastic bag over it, or a black piece of cloth.
3) alligator clip wire
4) aluminum foil or copper wire (NOT stainless steel)

I use a single-terminated crystal with a flat end, that is about the size of a fist. I have had good results with facing the pointed part towards me, as well as the flat part. Both appear to work. This setup is all I have experimented with, so I can not comment on any other setups. Experiment.

Wrap the middle quartz crystal with aluminum foil or a copper wire. Do not use insulated wire. Use tape or some adhesive to keep the metal firmly in place, but be sure to leave some part of the metal exposed so you can connect it later. Do NOT use stainless steel for any reason, the magnetic property of iron in stainless steel is detrimental for our purpose.

Using an alligator clip wire, attach the RED (positive) clip to the copper wire or aluminum foil wrapped around the crystal. Leave the BLACK (negative) clip to the side, unattached. Keep stainless steel as far away from the crystal as possible! That includes the alligator clip ends of the wires you used. We used aluminum or copper for a reason - they are not magnetic!

Turn on your frequency generator and make sure the device is set to send out Pulsed DC, or use a fully positive offset.

Run frequencies. Share your results. Pay attention to weather changes in your environment, as well as any nosy neighbors. Don't be stupid. People in your entire neighborhood will be affected by what you run. Don't be evil either.

NOTE: There is a side-effect to this method - some amount of DOR (Deadly Orgone) will be produced (in addition to good Orgone). So I highly recommend purchasing a cheap orgonite tower buster to place next to the quartz crystal, touching the metal part, in order to neutralize this DOR. By the way, this appears to only occur when you use pulsed DC... I do not have this problem when I use a completely negative offset (-). AC gets more complicated because you have to attach BOTH alligator clips to the metal around the quartz, and this could shortcircuit your generator. Just to be careful, only experiment with a fully positive offset, never in the middle (AC, centered at 0) or completely negative. In the F165 programming language, these would be the commands "offset 100" and "offset 0".

There is another side-effect but it's harmfulness depends on your point of view. First, let me remind readers that Orgone was named after the orgasm. Applying a positive offset pulsed electrical charge to a quartz crystal this way appears to make everyone around you, including you, sexually aroused... But this is a topic I will explore in another entry.

Add This Entry To Your CureZone Favorites!