Email This Message to a Friend!
Message URL: http://www.curezone.org/blogs/fm.asp?i=2441220
How To Break In A New Gun Holster
(How to Break In a New Gun Holster
)
The amount of effort and time required to break in a new gun holster will vary widely depending on the manufacturer.
Date: 7/14/2021 11:34:55 AM ( 3 y ago)
The amount of effort and time required to break in a new gun holster will vary widely depending on the manufacturer. For example, Mitch Rosen holsters are unbelievably tight and require a significant amount of break-in, while Don Hume holsters can generally be broken in within a few days.
How do I break in a new holster?
Most all new leather holsters will require some breaking in before they function as they should. This is perfectly normal. If you take a look around the Internet, you'll see some exciting advice on how to break in a holster.
Here are some don'ts:
-
Don't wet the holster and try to re-mold it to the weapon. If you think some type of action like this is necessary, send it back to the manufacturer.
-
Don't use products such as mink oil, saddle soap, or leather soap. While these agents may work great on saddles and baseball gloves, they are unbelievably bad for holsters. Not only will they probably discolor the leather, but each of these items contains chemicals that are designed to soften the leather. The softening chemical will cause the leather to lose its form and shape that the manufacturer works hard to mold. You'll end up with a holster that looks and functions like a wet noodle.
-
Don't heat it with a blow dryer, and then try to re-form it.
-
I could go on, but I think we've covered the basic don'ts.
To break the holster in, you can do the following (NOTE - All are done with an UNLOADED weapon):
-
Insert the UNLOADED weapon into the holster and fully seat it down. Once the holster has been fully seated (seated means inserted in the holster all the way), leave it in the holster for a few days. This will allow the leather to stretch out just a bit around the weapon slowly.
-
Put the holster on. Take the UNLOADED weapon and start doing repetitive holstering and draws over some time. I usually try to do this while I'm watching TV. Each time, make sure that the weapon is fully seated and fully drawn from the holster. In the beginning, this operation will be complicated to do but will get easier as the holster breaks in. I'd shoot for, say, 50 holster/draws in the beginning.
-
Only use the following method if the previously mentioned methods don't work. Get a skinny plastic bag like the ones that are used in a grocery store. Could you make sure they are ultra-thin? I wouldn't recommend a garbage bag or anything that thick as you'll end up with an overstretched holster. Insert the UNLOADED weapon into the plastic bag and wrap the bag very tightly around the holster. Ensure that the bag is very tight around the gun to avoid adding too much extra width to the weapon. Once the firearm is appropriately wrapped, fully insert it into the holster and let it sit for 24 hours or so. The idea here is that the bag adds some ever so slight extra width to the weapon.
These instructions should get you started on the path to breaking the new holster in correctly.
Popularity: message viewed 164 times
URL: http://www.curezone.org/blogs/fm.asp?i=2441220