Re: Putting MMS on toxic skin rashes

Internal use may well help clear them up or bring them out
I've not done it topically myself but it has been gone over several times
These are the instructions from Jim Humbles site


5. Topical Treatment (on the skin)

There are many problems of the skin usually causing sores or rashes. They could be poison oak or even cancer. Most should have Miracle-Mineral-Supplement applied directly to them. The best way to do this is by spraying. The way I do this all the time is to use a 2 ounce spray bottle that makes a fine mist. I take an empty 2 ounce spray bottle and add 20 drops of Miracle-Mineral-Supplement and 100 drops of 10% citric acid solution (you could use lemon juice filtered through a coffee filter). I wait the customary 3 minutes and then fill the bottle with water. (Could be distilled water, but then any clean water would do). This bottle of Miracle-Mineral-Supplement will stay activated for about 3 days. That’s because of the extra strong mixture.

I then use this to spray any sore, wound, or skin eruption that might occur. Outside the body requires a much strong solution. You can spray a sore up to once an hour. Allow the solution to dry on the body. It is the strongest and does the most good just before it dries. Also spray this on athletes feet and fungus on the feet. After it is dry the area can be rinsed off if you like. It’s not necessary. If the spray cause pain of burning then reduce the strength of the solution by pouring out 1/2 and filling with clean water. Keep reducing the strength in this manner until the spray does not cause burning, however, if this does not seem to work in a rare few cases it might be a fungus that MMS cannot touch. In that case, go the the home page and look under fungus protocol.

As I mentioned wounds should be sprayed as soon after they happen as possible. It will decrease the healing time by a great deal in most cases as microorganisms are mostly the cause of slow healing.