Date:   6/21/2015 5:06:49 PM ( 10 y ago)
Hits:   3,209
URL:   https://www.curezone.org/forums/fm.asp?i=2260991

0 of 0 (0%) readers agree with this message.  Hide votes     What is this?

Background: i been using ozone for years for odor remediation however they all operate off of ambient air. I just recently purchased 3 10 g/hr ozone generators made with a quartz tube that i can hook up oxygen to and i have an oxygen concentrator. i purchased the oil making kit from promolife and purchased zoe organic extra virgin olive oil.

My fist try:

setup: 10 g/hr ozone generator with air pump going into air dryer then quartz ozone tube resulted in lots of foam in my flask after a day and a half(most likely from nitric) i than turned off the air pump and hooked my oxygen concentrator and had it going and different lpm from 1 - 5 mostly about 2/lpm

Results: After 24 hours on oxygen at 10 g/hr ozone my oil become clear, lots of little bubbles (air bubbles or ozone bubbles), very very thick, never changed into a cream color. At this point i thought it was done and that is when i found out how thick it was and worse yet it was more sticky, so sticky and thick it could not be spread.

What did i do wrong?

wrong oil?
to much flow for 1000 ml oil?
should of left it keep going longer?
Nitric ruined it?

how do i clean up my oil making stuff so far i had to use mineral spirits to clean outside of flask and somewhat the inside of the flask. would acetone or muratic acid work better?
 

<< Return to the standard message view

fetched in 0.02 sec, referred by http://www.curezone.org/forums/fmp.asp?i=2260991