Date:   6/11/2015 9:25:58 PM ( 9 y ago)
Hits:   4,803
URL:   https://www.curezone.org/forums/fm.asp?i=2259054

The diodes only work when wired correctly. Meaning... you won't get any current limiting if they're connected backward. Which you can easily observe by wiring a multimeter into your circuit and measuring the load(I like using a small light-bulb). - which I'd highly recommend btw.  That said, ideally, you'd want two(2) multimeters in your setup. (1) to watch your voltage drop AND (2) to watch and monitor your current load. As this will provide an wealth of information insofar as monitoring and improving your craft. Not to mention, gaining a familiarity with the dynamics of colloidal silver processing. 

Here's a simple diagram showing how you'd wire a single current limiting diode vs. multiples into your circuit

PS. I like diodes for their simplicity. ie, I make CS using voltages ranging from 85v down to 30v. Of which, I simply pick the appropriate diode for the job(44mAh in my case) and be done with it.

Hope this helps

<< Return to the standard message view

fetched in 0.00 sec, referred by http://www.curezone.org/forums/fmp.asp?i=2259054