Date:   9/1/2011 8:11:17 PM ( 13 y ago)
Hits:   2,411
URL:   https://www.curezone.org/forums/fm.asp?i=1853859

I am building an ionic foot bath using pure Titanium
electrodes. These are sized as follows; 1/2 inch wide,
9 1/2 inches long and .050 inch thick.

The two electrodes stradle a 1/2 " diameter pvc plastic
pipe. The pos and neg battery charge leads are then attached
to the electrodes.

The water in a large tub has 1 tsp of Sea Salt in solution.
The electrodes are submerged in the water.

The battery charger is 2 - 8 amps at 12 V.

The problem is when leads are connected no current registers on the charger and no current is flowing.

Question: Is the current too high? Should I use a 500
milliamp charger? Is the 1/2 inch separation too much?

The electrodes have an oxidized patina. Could this be impeding current flow?

Also, some ionizers use a wrist band attached to the ground of the ionizer, some ionizers do not use wrist straps.
Are these necessary?

Thanks
 

<< Return to the standard message view

fetched in 0.03 sec, referred by http://www.curezone.org/forums/fmp.asp?i=1853859