Date:   4/12/2010 7:13:11 PM ( 15 y ago)
Hits:   20,984
URL:   https://www.curezone.org/forums/fm.asp?i=1604990

My homemade system utilizes a magnetic stir bar and magnetic stir plate of my own design, and its constant current engine is an LM334Z. My electrodes have been set at about 1" apart. Perhaps I need to increase the distance between them? It does seem that at 1,000 uA of constant current it is taking far too long. I'm beginning to think that I need 1,000 uA per square inch of electrodes overall.

Did you actually measure yours at 1,000 uA (1 mA), or are you only assuming it to be at that value?
 

<< Return to the standard message view

fetched in 0.02 sec, referred by http://www.curezone.org/forums/fmp.asp?i=1604990