Date:   11/1/2008 6:17:12 PM ( 16 y ago)
Hits:   8,588
URL:   https://www.curezone.org/forums/fm.asp?i=1290289

0 of 0 (0%) readers agree with this message.  Hide votes     What is this?

Hello to the forum

I purchased an original clark zapper de luxe 2006 and following the instructions of management, always gives the message "no load" after a few seconds of "start".
The wristband is moist and well-connected to the zapper.
I note with the oscilloscope wave output that is not always positive (as it should) but centered on zero with symmetrical sides positive and negative, and a range of 2 to 3 V and maximum output peak to peak.
The amplitude output is not between 9 and 15V as shown the instruction manual.
Someone has this zapper that can tell me if this is normal?
Thank you and greetings
 

<< Return to the standard message view

fetched in 0.00 sec, referred by http://www.curezone.org/forums/fmp.asp?i=1290289